Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

July 2015 Blog Posts (3)

Tiki 21. Parts layout on the 15mm plywood sheet.

Bonjour,

I started to loft yesterday, making templates for the 15mm sheet of the Tiki21.

I take careful mesurements, then tried to put everything on the 1200 x 2400 plywood sheet. Impossible. I cannot put everything. I finished with no space for one rudder.

Mesured again, and agin. Same results, can't find any mistake on my side.

So, question is: did some of you faced the same problem? I will if necessary find a piece of plywood for the remaining part, but I'd like to know… Continue

Added by Éric Bouvéron on July 25, 2015 at 6:16am — No Comments

Before I order West System, ask help for clarification

Bonjour,



I am now on the way to order the resin, and found West System in Shenzhen,China.



I am on for a Tiki 21, and, if some have experience in the building of this model



1-Are quantities indicated in instructions correct (no need to have more of a articular item?)

2-It is asked for : 406A 0.275 kg Colloidal Silica and 409B 4.5kg Microspheres (for fillets) OR

407B 3.5kg Low Density Filler (for fillets).

Is the reference 407B replaces bothe 406A… Continue

Added by Éric Bouvéron on July 15, 2015 at 3:19am — 1 Comment

About the Wood Triangular Section

Bonjour,

All wood has been sourced now, but the "Triangular Section". Not able (capable?) to find it standard, (here in China, Shenzhen area )and since it is not in the form of a "square triangle", (BC² = AC² + AB²) I hesitate on what to order to mill it myself with my hand circular saw mounted on a table.

I am on a project for a Tiki 21, and the base of the wanted triangular section is 32mm, while the sides are 25mm. Or, "Imperialy speaking" base 1 1/4" and sides 1". (I just…

Continue

Added by Éric Bouvéron on July 7, 2015 at 2:57am — No Comments

© 2017   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service