Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Anybody out there got any ideas about using pre made wooden beams for cross beams? I have a tangaroa mk4 here in Australia and have laminated 2 beams so far but it's lookin like I need another but trying to avoid the process again due to working space.

Views: 256

Reply to This

Replies to This Discussion

I have a vague recollection of this coming up before, have you had a look in the archives?

There are a ton of reasons not to do it.  Like that the beams are engineered to carry a different kind of load. do not have the curved shape, etc...  Can theoretically be succesfully wested if the sections of the lams are too thick. Before I considered that option, if the issue is one of the I beams that use extensive lamination to come up with a solid I shape, I would consider using a ply box beam.  Those are very fast to build, and very good beams.  Sure, you would be off the reservation a little, but nothing like the extent of a glulam.  Depending on the size of your boat, there are existing ply beams you could get a substitution order on.

Hi Matt - I have used a factory laminated pine beam for one of the beams on my Pahi 42. I was told they use waterproof glues, and so far after about 3 years it is fine. I have similar space and time problem - the weather here in winter/spring is so cold that I can't do any epoxy work outside until May, and my workshop won't take a 7m beam! My opinion was that the factory made lamination would be far better quality than what I would achieve. It is shaped and covered in 2 layers of glass cloth and epoxy & finishing coats.

Thanks for your help guys,I'm researching what's around now...

Reply to Discussion

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service