Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Anybody with some ideas trying to move my 28 foot Wharram three blocks to the boat ramp, thank you from Texas

Views: 365

Reply to This

Replies to This Discussion

Maybe on a truck, on a pick-up or with a trailer?

Regards from Austria ;-)

Attachments:

Thank Buddy

I used a truck to move my Tiki 26 almost 100 kilometers. It was a small truck, and we had to make two trips, one hull at a time. Also, I needed a lot of friends to move the hulls (we are not very strong). But it was fun!

Looks good thanks

I transported mine 2000km. No issues.

You didn't say if your boat was assembled or not or if the three blocks were hilly or flat. I would get a permit to move it early in the morning (if in a built up area) and a) if it were one hull at a time I'd use a simple plywood cradle with wheelbarrow wheels and a few helpers and push it. If b) fully assembled it would need a more substantial cradle I suspect and more of a crude trailer design with vehicle support.

The builder if my tiki 26 moved one hull at a time 1km to a beach, on his own using the simple cradle method above.

I'm sure you will figure something out

Thanks for your help, I got her to fly for the 3 blocks to the bay!

8E852CEA-0A88-4E71-97FE-BDB67F2D1622.jpeg

Woohoo! That's way better than pushing. 

Glad it's worked out for you

Thx

Reply to Discussion

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service