A Photo & Discussion Forum for Wharram Design Enthusiasts
Hi, That was a nice day, with light wind.Some problems made us start late, and we ended to a small island, not as far as we wanted to go first, where we had an unhealthy lunch. However, I think I do…Continue
Started this discussion. Last reply by Ian Bamsey Jun 1.
Bonjour,I wish to put an asymmetric spinnaker on my Tiki 21. Bowsprit it ready, thanks to Gratitude, and I have asked sail makers but... I think that they are very optimistic in the sizes they…Continue
Started this discussion. Last reply by Éric Bouvéron Apr 2.
Bonjour,I am looking at an anchor point for my clew block for an assymetric spinaker, an I found a picture of a block simply tied on a laced chainplate of a Tiki21.This is a very good angle for an…Continue
Started this discussion. Last reply by SoLong Mar 18.
Éric Bouvéron has not received any gifts yet
Posted on July 25, 2015 at 6:16am
Posted on July 15, 2015 at 3:19am — 1 Comment
All wood has been sourced now, but the "Triangular Section". Not able (capable?) to find it standard, (here in China, Shenzhen area )and since it is not in the form of a "square triangle", (BC² = AC² + AB²) I hesitate on what to order to mill it myself with my hand circular saw mounted on a table.
I am on a project for a Tiki 21, and the base of the wanted triangular section is 32mm, while the sides are 25mm. Or, "Imperialy speaking" base 1 1/4" and sides 1". (I just…Continue
Posted on July 7, 2015 at 2:57am