A Photo & Discussion Forum for Wharram Design Enthusiasts
Thanks for the add to the group. Can anyone give an approximate cost to building a Tiki 38? Regarding the lashings, can the lashing be done by oneself, or is Professional help and machinery required? Thanks, Jay.
Can't give materials cost but yes you can do the lashing on your own. A block and tackle is a help plus I have stainless steel caps over the top of each beam with an oak wedge for further tightening. Good system.
That is a relative question. Where are you located? Materials have different costs in different locations. Do you plan to build per plans or modify? Material costs fluctuate with changes. Best materials available or average materials? Are you talking about just the bare boat? No cushions, no electronics, no engines, minimal electrical, bucket for head, one part paint, etc., etc., etc. Or are you pulling out all of the stops? Do you already have a place to build the boat? Do you already have the tools necessary? There are just too many variables to give accurate costs without more information.
This is based on rough U.S. bargain hunting pricing: Just the plywood, soft wood lumber, fiberglass, and epoxy - all purchased in bulk - will set you back no less than $25-30k. Add hardwood lumber (there is a significant requirement for this not included in the materials list), fasteners, basic hand tools, and consumables will add another $10k minimum. Standing/running rigging and sails adds another $10k. Two Yamaha 9.9 saildrives with remote gear is another $6-7k. Paint? No less than $1k latex or oil paint, $2k for epoxy paint, or $3-5k for urethane paint (U.S.) Now add building (or rent), electricity, and other overhead for 3-7 years....
....and we have not added the electrical systems, plumbing systems, navigation, cushions, canvas, refrigeration, electronics, or any of the other things most modern ocean going vessels might have aboard.
Lashings can be done by hand, but some type of lever is better to get them nice and tight, then add wedges.
I recently did the math on my sunk infrastructure costs: Buildings, storage, electricity, garbage, tools, etc. I was quite shocked that it came to just shy of $17,000, (I thought is was about $7k) and I have a large number of tools that we are using that are borrowed, which would easily add thousands more.
Hi Jay, you may have already seen my reply to your question on lashings on my Facebook page, but for anyone else interested in this, the link is here
© 2023 Created by Budget Boater. Powered by