Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

boatsmith's Discussions (347)

Discussions Replied To (285) Replies Latest Activity

"Also we use 6mm line for our small boat rudder lashings"

boatsmith replied yesterday to Up and down movement of the rudders

10 yesterday
Reply by boatsmith

"We only notch the lashings in a little bit. There is still a gap. Regarding the dyne…"

boatsmith replied yesterday to Up and down movement of the rudders

10 yesterday
Reply by boatsmith

"There is the thickness of the lashing rope between the rudder and the sternpost.They…"

boatsmith replied on Sunday to Up and down movement of the rudders

10 yesterday
Reply by boatsmith

"Beam blanks being laminated from foam solid fiberglass in-layed in way of the bea…"

boatsmith replied Jan 30 to Tiki 8m Build

4 Jan 30
Reply by boatsmith

"Deck mold sprayed with gelcoat deck with foam and glass being faired bulkheads laz…"

boatsmith replied Jan 27 to Tiki 8m Build

4 Jan 30
Reply by boatsmith

"frappings are the secondary lasing around the two sides of the primary lashing betwe…"

boatsmith replied Jan 27 to Dynema for lashing beams

5 Jan 27
Reply by Frank Higgott

"we wrap the hinge line around an axe handle for leverage on each turn. Once e have a…"

boatsmith replied Jan 21 to Up and down movement of the rudders

10 yesterday
Reply by boatsmith

"this is how we do it. double braid polyester lashings with dynemma frappings. sweet"

boatsmith replied Jan 16 to Dynema for lashing beams

5 Jan 27
Reply by Frank Higgott

"i would think that there is probably some rotten wood happening in the stern post.…"

boatsmith replied Dec 26, 2017 to Repair Tiller lashing holes

2 Dec 28, 2017
Reply by Andrew Cassingham

" I use aluminum masts with a big roach full batten marconi sail"

boatsmith replied Nov 22, 2017 to Tiki 30 mast measurements

16 Nov 27, 2017
Reply by Maxim Jurgens

RSS

© 2018   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service