Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Final checks on my transom/engine well arrangements for new Tiki 21 platform. I've gone for 12 degree slope and should just clear the rear beam. This is a much lower arrangement to get the cav plate down 250mm below the water. Honda's minimum is 100mm. I'm trying to reduce the typical Tiki 21 cavitation problems.

Rating:
  • Currently 0/5 stars.

Views: 161

Comment by Roger on March 2, 2014 at 11:32am

Looking good Ian. Another thing I did to reduce cavitation was change to the small pitch propeller - it made a huge difference, even with my mounting which is standard height. With the standard prop it would cavitate at half throttle in smooth water - with the small pitch prop I can get full throttle in smooth water with no cavitation. In rough water, I can maintain drive at half throttle whereas there was hopeless cavitation with the standard pitch prop.

Comment by Ian Bamsey on March 2, 2014 at 2:46pm

Thanks so much Roger. Your advice and experience is much appreciated. I'd read your blog on the prop pitch before and I will buy a new prop for the motor in due course. It's yet another expense to add to all the rest: paint, rigging, mooring, insurance..... Wow I hope we have a good summer after all this.

Comment

You need to be a member of Wharram Builders and Friends to add comments!

Join Wharram Builders and Friends

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service