Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

What is the first knot to tie when joing the beams to hull

I used a bowline at the end of the line pass the end through the loop and pull tight in the opposite direction . I am concerned that the line pulling across the loop will cut through the line .... Perhaps a rolling hitch? Any advice would be welcome .

Views: 262

Reply to This

Replies to This Discussion

Hi Patrick,

I used the same method and have only good experience with this.

Much fun on the water!



The same method here, no problems or signs of damage.

Thank you for the confirmation. Cheers

Reply to Discussion


© 2021   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service