Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

I found a tiki 26 that needs to be restored a couple hours away from me and am finally picking it up in the next week or so. I was hoping that someone has some dimensions for a set of stands that I could build before going to pick the hulls up so I don't have to improvise when I get there.  Any help is greatly appreciated.

Views: 119

Reply to This

Replies to This Discussion

On my Tiki30 I roughed in the stands [3/4" ply] slightly larger than plans .  After I placed the cradles, I  screwed on 'sleepers' of 1x scrap to fit the hulls - sandwiched the cradle edges between 2 of these sleepers.- they held up for the entire life of the project .

Hi Matthew. Congrats on your new project! When are you going to pick up the boat? Unfortunately, I am traveling, but will be home next week. I could photograph and measure my cradles then if it would still be helpful.

Reply to Discussion

RSS

© 2017   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service