Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

kim whitmyre's Discussions (378)

Discussions Replied To (314) Replies Latest Activity

"Perhaps you should speak to Rory McDougal with your issues. . ."

kim whitmyre replied Jul 22, 2010 to Wharram Wingsail

24 Sep 17, 2010
Reply by Jeff Kittle

"Ron, re the hanks: These are not hard to splice up yourself, but they can also be p…"

kim whitmyre replied Jun 28, 2010 to Rigging loads for T38

25 Aug 25, 2010
Reply by Björn

"Jamie, I'm sure some of the Tiki 38 builders will chime in here soon. Are you workin…"

kim whitmyre replied Jun 28, 2010 to Rigging loads for T38

25 Aug 25, 2010
Reply by Björn

"Jamie, what I did on my tiki 26 was look up the breaking and working loads on the 5/…"

kim whitmyre replied Jun 28, 2010 to Rigging loads for T38

25 Aug 25, 2010
Reply by Björn

"Last reported position was 55 miles SE of Newport, under the eastern side of Martha'…"

kim whitmyre replied Jun 26, 2010 to Rory +Jester challenge

9 Aug 8, 2010
Reply by kim whitmyre

"However the sheet is run, I would not use a cleat for it. The sheet may need to be l…"

kim whitmyre replied Jun 23, 2010 to Tiki26 jib rigging

7 Oct 24, 2010
Reply by Brandon Gamble

"I've never sailed a tangaroa, but here are some comments on tacking a tiki: Tammy w…"

kim whitmyre replied Jun 21, 2010 to Ackerman angle

13 May 15, 2012
Reply by andy solywoda

"Here's an old photo of Vaea's aft end that shows the starboard tiller fairly well:…"

kim whitmyre replied Jun 20, 2010 to Ackerman angle

13 May 15, 2012
Reply by andy solywoda

"That sounds like a reasonable gap, Mark; mine was really excessive! It was Steve Tur…"

kim whitmyre replied Jun 18, 2010 to Ackerman angle

13 May 15, 2012
Reply by andy solywoda

"Do you have the lashing system on your rudders? More experienced folks than me say t…"

kim whitmyre replied Jun 18, 2010 to Ackerman angle

13 May 15, 2012
Reply by andy solywoda

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service