TIKI 30

102 members

Description

TIKI 30 owners, builders, and general questions about the Wharram TIKI 30
Comments Discussions Members

Tiki 30 - Gaps for bulkheads 1 and 7?

by Ricardo Aráoz

Dec 23, 2015

Hi all,

Rainy day, so I'm checking the plans trying to get ahead of the construction and I have a big doubt. In the assembly booklet (page 2) says you must leave a gap for bulkhead 6 and bulknead 2 between the keel and the timbers that go between the keel and the stem and stern. But it does not show a gap between the timber and the stem for bulkhead 1 nor a gap between timber and stern for bulkhead 7. Bulkhead 7 has no notch but bulkhead 1 has a 35mmX10mm notch.

Should I leave a gap between timber and stem/stern for the bulkheads? Do the bulkheads rest on top of the timber? On top of the T section? What is the 35mmX10mm notch for?

If anyone has solved this I would very much appreciate some tips.

Thank you and merry Christmas.

Ricardo

  • up

    Ricardo Aráoz

    In Sheet 1 (structural details) the drawings show both bulkheads going all the way down, that would be ok with bkhd 7 (though it would contradict the assembly booklet that shows no gap), but that would mean it would be two (2) timbers between the keel and the stem (as blkhd 1 would be cutting them apart) and there is no mention about it. And what would the 35mmX10mm notch in blkhd1 be doing there? Haven't been able to find a sensible answer.

    Dec 23, 2015