Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Hi Guys,
has anybody used the whip-staff arrangement on the Tiki 31 - if so which arrangement was used. I would like to used a steering butt cannot afford the yacht shop prices.
Thanks Pieter

Views: 379

Reply to This

Replies to This Discussion

I have no idea what a whip-staff is.

Are you talking about a tiller extension?

You can make one yourself if you do not want to buy one.

whip staff is like a  vertical mounted tiller connected by lines to the rudder, push staff the way you want to go, I put 1 on my first cat as the tillers were too far back  and too short for comfortable steering, You could mount one inside if you wanted, or use it to mount a tiller pilot in a sheltered position. 

I am currently working on something like this for my boat. I built three identical quadrants with a 30" radius out of marine ply. I am planning to mount them on my rudders perpendicular to the axis, and the third will be mounted on the rear of my cockpit with a tiller arm attached (the driving unit). I believe that this setup will eliminate the slack that occurs when you go hard over with cable systems that use standard (straight) tiller attachments on the rudders, and allow for me to have a tight tiller controlled steering system. I like steering with a tiller because of the feedback, this is the only way I could think of to have a tight tiller system with the placement of my cockpit. Also depending on how I mount the driving quadrant, I can set it up to steer either like a normal tiller, or like a whip staff. This is going to be a winter project for me to install. I will post photos when I can.

Hi Forrest,

thanks for the comments - will be interesting so see the photos, and how it works - I am still debating on how to go about it.

Forrest Nichols said:

I am currently working on something like this for my boat. I built three identical quadrants with a 30" radius out of marine ply. I am planning to mount them on my rudders perpendicular to the axis, and the third will be mounted on the rear of my cockpit with a tiller arm attached (the driving unit). I believe that this setup will eliminate the slack that occurs when you go hard over with cable systems that use standard (straight) tiller attachments on the rudders, and allow for me to have a tight tiller controlled steering system. I like steering with a tiller because of the feedback, this is the only way I could think of to have a tight tiller system with the placement of my cockpit. Also depending on how I mount the driving quadrant, I can set it up to steer either like a normal tiller, or like a whip staff. This is going to be a winter project for me to install. I will post photos when I can.

Reply to Discussion

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service