Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

In the plans of Tiki 31 it is suggested that the steering would be arranged with a "whipstaff" or a sort of  tiller bar replica, connected to tiller bars with system of cables. I wanted to use a steering wheel. I figured it should work with the same sort of cable-and-block system described in the plans. Well, it did not. When turning the wheel clockwise the cable pulls the starboard tiller bar the way it should. But because the tiller bars are curved, the port tiller turns somewhat less, and soon the cable to the port tiller is goes slack.

How have you arranged the wheel steering? Are the cables coming from the wheel attached to one tiller bar only, having the connecting rod turn the other tiller. Have you added some sort of a segment? Or have you connected the cables coming from the wheel to both tiller bars? In that case how have you been able to keep both cables taut even when one tiller turns more than the other?

Views: 838

Reply to This

Replies to This Discussion



Ok. Thanks, I found Your previous post quite useful! I know now how I will arrange it.

I had the same issue on my 40 foot Tangaroa. The previous owner had "solved" the problem of the slack cable by putting a section of elastic on each cable to take the slack out during turns. I didn't like this solution, so I fabricated a pair of quadrants out of plywood, and installed them on the rudders. now my cables maintain the same tension for all rudder angles!

Reply to Discussion

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service