Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

David Kamper's Comments

Comment Wall (5 comments)

At 3:45am on October 31, 2020, Graham Jackson said…

G'day David, I am planning on restoring my Hinemoa , here in Queensland , but using aluminium cross beams . I note that yours are round section alloy tube , could you please advise the cross section dimensions and the wall thickness used ?

graham

At 1:42am on November 2, 2020, David Kamper said…

Hi Graham

I made the beams 3400mm wide, a little wider than standard i believe ..

The Ali tubes were 150mm diameter and 5mm thick wall , a bit of an overkill but would never fail 

Had a local Ali boat building firm weld them up for me ..

i  also used50mm tybe for bow and stern to hang nets off and a sort of dolphin catcher on bow tube ..   

At 2:27am on November 2, 2020, Graham Jackson said…

David , Thanks for that advice . Certainly takes out the guess work for me . Just out of interest what was the final weight of a beam compared to the timber originals ?

Graham

At 7:28pm on February 3, 2021, David Kamper said…

At 7:29pm on February 3, 2021, David Kamper said…

You need to be a member of Wharram Builders and Friends to add comments!

Join Wharram Builders and Friends

© 2022   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service