That's varnish over the epoxy. I didn't know about UV resistant epoxy at the time of coating the hull panels. Would be less work! Not as smooth and very shiny though. I'm still debating on adding some paint below. For now, just move along on the build.
Tabernacle has been done for a long time. I went with 5 coats of epoxy, 3 coats of epoxy primer and 6 coats of linear urethane paint. # of coats of epoxy and epoxy primer were for sanding. The paint had to be put on thin, hence the 6 coats. Can't do varnish in this environment. Oh, and yes, it's HOT down here.
Mark? Thank you my Pod did come out reasonably OK at least it fits between the hulls. I fear I neglected to realize how much the sides would deflect as I applied to the rooftop resulting in a kind swaybacked side ,the bulkhead aft and the windshield forward the problem is obvious and I had them well braced and they are good . sides looked so good that I was not worried but once the slimy glue was in place and the rooftop screwed on --well too late on this one the next one will be better.