Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Rating:
  • Currently 0/5 stars.

Views: 238

Albums: Pahi 63
Location: Bataan, Philippines

Comment by Tom on April 10, 2010 at 10:03pm
Nice looking shot.

How will you attach the rudders without the plate and pin mounted in the skegs?

In my plans, those holes I see are for the bridle in the bow, not the stern. Have you realized a better way to stabilize the stern?
Comment by Geminidawn on April 11, 2010 at 1:42pm
The plate and pin will be routed to accomodate at a later date when the rudders are being made up so the Stainless Fabricator dosen't need to make a return visit and can do it all in one go.
The Filipino's don't sail very much and they're more used to the motorisd Banka so sailing and sailing rigs is a bit of a mystery to them. Unfortunately those holes were drilled in my absence. I am however thinking on putting a solid deck rather than netting aft for more of a working area so I may need extra structural support if not I'll be giving the trigger happy guy with the drill some resin and dowels. On saying that there will be up to 35 people working on it this summer to make up for lost time so there will without doubt be more discrepancies.
Comment by Iain & Cherry Mae Cairns on April 4, 2011 at 4:30pm
Not a "CAPTAIN COOK" then, WOWOW big boat.

Comment

You need to be a member of Wharram Builders and Friends to add comments!

Join Wharram Builders and Friends

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service