tiki 38 hull thickness

Hi, the study plan for Tiki 38 specifies plywood thickness of 9mm for the hulls. Is this (+cloth+epoxy) the final hull thickness? Or is one supposed to glue two layers of plywood? If not, is this enough for a relevant puncture resistance?

Regards.

Gvido

Replies to This Discussion

Permalink Reply by gb on October 14, 2019 at 6:34am

Yes that was my intention, but the question is how many layers are there in a hull. I would expect that at least below the WL there are more than 1.

Chuck Valley said:

Buy 9mm plywood,

Permalink Reply by Vili on January 9, 2020 at 9:47am

stringers+9mm ply+fiber glass coating...this is what gives the final good resistance