Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Does anyone know roughly what a Tiki 26 beam should weigh - ideally a grp front one

Thank you - Johnny

Views: 232

Reply to This

Replies to This Discussion

I can weigh one for you. A plywood front one, sorry. Remind me if I forget. Cheers

Thank you!

23kg exactly

Thank you SO much - johnny

ps any idea how much a grp one would be?  I can barely lift my rear one.  It was rebuilt and I thnk pretty well filled with epoxy...

I move all my beams by myself without trouble and I am of very average strength and 60 years old. The mast beam would be a bit heavier than the front one maybe 30kg.

A GRP one would probably always be heavier than a plywood one. Depending on the plywood used it can be more or less light. GRP doesn't float but doesn't rot. Conversely ply floats and rots! 

My boat came with light hulls and beams but with a very heavy ipe deck (tabebuia, the lumber used for marina docks) that I am going to turn into fence posts! I am first going to use trampolines and see how it works.

Cheers

Thank you - ha thats what I thought - but the grp beams are built on ply framework and that rots!

good luck - ps I have a deck tent if that is of interest?

Hi Johnny, hope you don't mind me bringing this thread back alive again.

I'm a little paranoid over my boats weight as I didn't build her and want to make some changes while it's here at home. It's been very well built using all the correct materials so I have no issues there. But the weight is unknown. So I just took delivery of a cheap set of Chinese crane scales and intend to weigh individual components as and when I can. Starting with the beams.

The scales have a + 9% error (so far) which I've subtracted from all weights so the numbers below are corrected. I would not trust them completely so just use as a guide.

I should also mention the beams are complete ie timber, ply, epoxy, fasteners, dolphin striker, fibreglass, filler and paint but no fittings except the end cleats.

FWD.  31KG

MAIN. 43.5KG

REAR 34.5KG

I've almost finished building a permanent crane on to my "Tiki Trailer" which will allow me to easily weigh each hull, cockpit and mast. I'll update these figures when I get that done.

Hope this helps someone.

Sounds a great project! - my rear beam is aluminium pole.  so i guess lighter. 

Reply to Discussion

RSS

© 2021   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service