Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Hello again,
I understand that it is necessary the epoxy coat to sand before making the filets in order to get a good bond.
How much the coated plywood shout it be be sanded? Slightly? Back to the wood?
Any info welcome,
Éric.

Views: 220

Reply to This

Replies to This Discussion

Hi Éric,

the idea is to roughen the surface so that the epoxy gets something to grip on to and the sanding also helps to ensure that the surface is free of contaminants like blush.  

So you need to sand enough to scratch the entire surface where the fillet will bond and it may be a good idea to sand with water and wash with water after you sand ( water removes blush ).

Perhaps you should get the WEST system book (large PDF ) http://www.westsystem.com/ss/assets/HowTo-Publications/GougeonBook%...

More on this page: http://www.westsystem.com/ss/use-guides/

Regards,

Robert

Thank you, Robert, nice and clear.

Therefore, it sounds better to coat all the sheets and sand the areas to glue before to cut and put the pieces together, must be more easy.

And your links are perfect, as well,

Regards,

Éric

Reply to Discussion

RSS

© 2024   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service