A Photo & Discussion Forum for Wharram Design Enthusiasts
This is the same situation as used with climbing/descending gear. One loaded line going to 2 anchor lines/ points, each anchor point/line has the same load. You could google it but from memory at a steeper bridle angle anchor line loads are half the main line, but at flatter angles like yours each anchor point can have a load greater than the main line load. eg 100 kg main line and 120 kg or more on each anchor point. So if you are keeping that angle make everthing extra strong.
Dave is right about the bridle loads.you have a trade off necessary here.the bridle load increases as the bridle legs get shorter. the jib gets smaller as the bridle legs get longer.
If the jib tack point is far enough forward, you might consider dropping the connecting beam onto the decks, in line with a projected forestay. Then it would help to drop the bridle leg attachment points further down the stems. This would improve the bridle angle that you are concerned with, as well as lengthen the lower spans, at the same time as allowing for a reverse dolphin striker to lift the bridle even further if needs be.
I would add a narrow ladder-like beam structure or a plank, lying forward of the mast, in order to take the jib tack even further forwards; it is handy to support the safety net as well as being good for footing when going forwards.