Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

patrick lennon's Discussions (81)

Discussions Replied To (62) Replies Latest Activity

"Location please"

patrick lennon replied Oct 14 to Tangaroa mk4 for sale (SOLD)

8 Nov 9
Reply by matt connolly

"The bulkhead was out of alignment when the sides were glued on . The bottom of the b…"

patrick lennon replied Sep 30 to Tiki 26 - Hull allignment issue

12 Sep 30
Reply by patrick lennon

"I had this problem and I just glued pcs. Of hardwood to the back of the beam."

patrick lennon replied Sep 27 to Tiki 26 - Hull allignment issue

12 Sep 30
Reply by patrick lennon

"I would think I would do the drawing on the plywood tape all the edges were you will…"

patrick lennon replied Sep 27 to Is it recommended to coat whole sheets of plywood with epoxy before any cutting?

12 Oct 23
Reply by Stewart Coates

"Also include 10 cm above waterline in calculations "

patrick lennon replied May 2 to tiki 26 square meters wet surface

4 May 3
Reply by adriano meis

"Rotating hatches from B Hasler fitted into the tops of main hatch could be a good al…"

patrick lennon replied Apr 9 to WHY PODS ARE NOT WIDER???

21 Apr 23
Reply by Ian Bamsey

"A very good solution for full width pod for tiki26 applicable for Tiki 30 . I found…"

patrick lennon replied Apr 6 to WHY PODS ARE NOT WIDER???

21 Apr 23
Reply by Ian Bamsey

"I have not heard of any project being completed within the designer estimated time.…"

patrick lennon replied Apr 3 to Time estimated to build a Wharram catamaran are they accurate?

19 May 9
Reply by agur paesüld

"I prefer 2 part poly Jotun for longevity and ease of application. I used small foam…"

patrick lennon replied Apr 2 to Two component paint

10 Apr 10
Reply by agur paesüld

"Just fine white sand. The sand from aquarium Shops is very clean . It is important t…"

patrick lennon replied Apr 1 to non skid paint tips

5 Apr 1
Reply by patrick lennon

RSS

© 2017   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service