Wharram Builders and Friends

A Photo & Discussion Forum for Wharram Design Enthusiasts

Axel's Discussions (85)

Discussions Replied To (76) Replies Latest Activity

"Perhaps console yourself with the fact that Wharram does not specify Okume and like…"

Axel replied Jan 8, 2011 to cold molded hulls

26 Oct 14, 2011
Reply by Tom

"Kerosene is fine for heating and cooking. It should also be almost universally avail…"

Axel replied Dec 26, 2010 to What Cruising Fuel?

4 Dec 28, 2010
Reply by Jeff Kittle

"Tom, I am building a T38 in New Mexico, mostly done but there are still some buildin…"

Axel replied Dec 21, 2010 to Looking for an opportunity!

3 Dec 26, 2010
Reply by Thomas Schmidt-Lange

"Unfortunately in an open forum an almost inevitable consequence is the occasional un…"

Axel replied Dec 13, 2010 to Electric propulsion

18 Dec 13, 2010
Reply by Chuck Valley

"Oops, sent the dimensions to Adrian by mistake. Anyway, the base is 20(?) mm ply, 2…"

Axel replied Nov 15, 2010 to Wind Vane Dimensions

9 Jun 26, 2012
Reply by andy solywoda

"The beam rests on hardwood blocks at both ends of the trough and does not rest or to…"

Axel replied Nov 15, 2010 to Beam Trough Advice

4 Nov 19, 2010
Reply by Jeff Kittle

"I have a small catalytic Propane heater in my van that runs off the small, green, di…"

Axel replied Oct 22, 2010 to How do I heat a Tiki 21?

66 Oct 28, 2014
Reply by Rusty Gesner

"If it's any help to you, I did this on my T38. From working on a Rescue boat years a…"

Axel replied Oct 20, 2010 to Solid timber Stems and Sternposts Tiki 26.

10 Oct 22, 2010
Reply by Lee Dilkes

"If I remember correctly JWD recommends exterior grade Doug fir ply for the sustainab…"

Axel replied Nov 11, 2009 to Plywood for the idiot boat builder...

4 Nov 29, 2009
Reply by Tom

"I've used East (from Noah's in Toronto) and West, started out West for 50 gallons an…"

Axel replied Nov 11, 2009 to Major Epoxy Brands compared to Cheaper Alternatives

19 Aug 25, 2016
Reply by dennis schneider

RSS

© 2019   Created by Budget Boater.   Powered by

Badges  |  Report an Issue  |  Terms of Service